Vehicle counting system for an open-air car park
Drivers who enter a car park that is already full have to turn round, often blocking the entrance and the road behind them. A vehicle counting system built on cameras can tell them, before they commit, whether a space is available.

Intro : Repurposing cameras to count vehicles, display availability and drive light signals
The Squiriel Park car park management suite now includes an application better suited to smaller sites. This new solution has been deployed on an open-air car park at a military site. It sits at the meeting point of two of our areas of work: connected systems and extra-low voltage for the cameras, signals and cabling, and custom software development for the counting application itself.
A lighter solution for smaller sites
Two counting cameras are used to manage occupancy on the outdoor car park of a barracks. When the estimated maximum number of available spaces is reached, a set of light signals facing the street tells drivers whether they can enter the car park or whether it is full.
The number of available spaces is displayed in real time and can be adjusted manually to allow for temporary visits, such as deliveries.
Why count at the entrance rather than space by space
On a multi-storey car park, each bay is usually monitored individually, with a sensor above every space. That approach is precise, but it assumes a ceiling to fix equipment to and a structure that is worth cabling. An open-air car park has neither. Counting vehicles as they cross the entrance and the exit gives you the figure that actually matters to a driver arriving from the street: is there room, yes or no.
The trade-off is worth stating plainly. Entry and exit counting tells you how many vehicles are inside, not which spaces are free or whether a vehicle is parked across two bays. For a site where the question is simply whether to let the next car in, that level of detail is enough. For a site where you need to reserve, charge or guide drivers to a specific bay, it is not.
What was put in place at the barracks
Two cameras cover the movements in and out. The count is compared with the maximum capacity declared for the site, and the result drives light signals positioned so that they are visible from the road, before the driver commits to the entrance. The manual adjustment exists because reality does not always match the count: a delivery vehicle occupying several spaces, an area closed off for works, an event bringing in vehicles outside the usual pattern. Someone on site can correct the available figure without waiting for an intervention.
Points to consider before deploying
Camera-based counting depends on conditions that are specific to each site: the angle available for installation, lighting at night, the width of the entrance and whether vehicles can pass side by side. A drift of a few vehicles over a long period is possible, which is why a reset procedure and a periodic check against a physical count are part of the operating routine rather than an afterthought. These are questions to settle during the site survey, not once the equipment is on the pole.



